Gm Brake Rotor Minimum Thickness Chart

Gm Brake Rotor Minimum Thickness Chart – # 4282333, disc brake component specifications. Posted july 13, 2017 who know the minimum rotor thickness fork these trucks? Most specifications for rotor thickness are found in the “base brake” articles. Measurements are required on the repair order and in the warranty claim submission for either operation.

Measure the brake rotor thickness 0.40 inches (10mm) inside the outer circumference of the brake rotor every 45° ( 1 / 8 of a rotation). We hope this helps you figure out what your rotor thickness is. Brake rotor least thickness been looking on aforementioned brakes on my 72 jimmy 4×4 also need some info. I plan to upgrade the brakes all nearby in 15.

Gm Brake Rotor Minimum Thickness Chart

The front rotors are 15” in diameter while the rear silverado brake rotors are 13” in diameter. Rotors should be replaced before they reach. To measure your rotor’s minimum operational thickness, place a micrometer at the thinnest point on the rotor’s surface where it meets the brake pads.

Multiple measure points should be taken and the lowest measurement should be recorded. Brake rotors are marked with a “minimum thickness” on the casting (usually 2 mm to 3 mm less than the new rotor thickness). Car support maintenance minimum brake rotor thickness minimum brake rotor thickness the correct operation of a vehicle’s braking system depends on various factors.

Warranty is given by gm holden ltd (trading as acdelco) of 191 salmon street,. Rotor thickness max 26.47mm or 1.042″ minimum thickness after refinish 25.04mm or 0.986″ discard thickness 24.3mm or 0.956″ light scoring of the rotor surfaces not exceeding. When it reaches what we call the.

They should measure 1 or less for the 1 (ld) brakes and 1.10 or larger for the 1.25 (hd) brakes. As shown here in figure 1 the base brake article contains a section titled technical specifications. Measure the rotor for original thickness using a brake micrometer.

Minimum Thickness Rotors